HS-02Intermediate
Gas Leak & Flame Detection
Adds optical gas imaging and flame detection on camera to the fixed point detectors, so a leak between detectors is still seen.
HSE, Emissions & SecurityAIIoT
HS-03IntermediateWave 2AIDomain
Methane Monitoring & OGMP 2.0 Reporting
In one sentence
Builds a methane inventory from measurements rather than from emission factors, at the level of detail OGMP 2.0 actually asks for.
The problem
Most reported methane numbers are generic emission factors multiplied by equipment counts. OGMP 2.0 level 4 and 5 require source-level and site-level measurement, and the gap between a factor-based inventory and a measured one is routinely large.
How it works
Source-level measurements from leak surveys, optical gas imaging and continuous point sensors are reconciled against site-level measurements to produce an inventory with uncertainty at each level. Where reconciliation fails, the discrepancy is reported rather than distributed across sources, because the discrepancy is usually the most informative number in the report.
Data required
- Leak detection and repair survey records with source-level quantification
- Continuous or campaign site-level measurement
- Equipment inventory with component counts and service classification
- Operating data: venting, flaring and blowdown events with volumes
What you get
- Source-level and site-level methane inventory with uncertainty
- OGMP 2.0 reporting package at the target level
- Ranked mitigation list by tonnes abated per unit cost
What it cannot do
Reaching OGMP 2.0 level 5 requires site-level measurement equipment the operator may not have, and this capability cannot substitute analysis for measurement. It will produce a level 3 inventory from existing data and will state plainly what equipment is required to reach levels 4 and 5, rather than presenting an estimate as a measurement.
Every capability page states a real limitation. If a vendor cannot tell you where their product stops, you are not being told the truth about where it starts.
Related capabilities
- HS-04Foundational
Intelligent Flare Monitoring
Watches the flare on camera to confirm it is lit, estimate how much is being burned, and detect smoking or incomplete combustion.
HSE, Emissions & SecurityAIIoT - DF-07Foundational
Automated Data Quality Control
Continuously checks incoming data for stuck sensors, impossible values, missing periods and broken units, and reports the field’s data health as a number.
Data FoundationITAI - HS-07Intermediate
Drone & Robotic Inspection
Flies or drives the inspection route so that people do not have to work at height or enter confined spaces as often.
HSE, Emissions & SecurityIoTAI - HS-08Intermediate
OT Cybersecurity Monitoring
Watches the control network passively for devices, traffic and commands that should not be there.
HSE, Emissions & SecurityITIoT