Meana Petro

Yacimiento

Balance de materia de gas — P/z

Paste reservoir pressure against cumulative production and read gas in place off the intercept, with z computed at every point rather than assumed constant.

Todas las herramientas

Datos de entrada

Pressure and cumulative production

Cumulative gas produced and the average reservoir pressure at that point.

FilaCumulative producedReservoir pressure
1
2
3
4
5
6
7

Resultados

Cargando el cálculo…

Este cálculo se ejecutó en tu navegador. Ningún valor que introdujiste se envió a ningún sitio, y nada se guardó.

Cómo se calcula

  • For a volumetric gas reservoir, P/z falls linearly with cumulative production: P/z = (P/z)ᵢ · (1 − Gp/G).
  • z is computed at each measured pressure from Dranchuk–Abou-Kassem with Wichert–Aziz sour-gas correction, so the plot is not distorted by a single assumed z.
  • OGIP is the intercept of the fitted line on the production axis, where P/z reaches zero.
  • Recoverable gas is read where the line crosses your abandonment pressure, which is what the recovery factor is actually built from.

Estándares que habla

Dónde deja de ser cierto

The straight line is the whole model, and it only exists for a volumetric, single-tank, gas-expansion reservoir. Water influx bends it upward and makes the extrapolated OGIP too large — in strong aquifer cases, twice too large — while a geopressured reservoir bends it the same way for a completely different reason, and the plot cannot tell you which. Average reservoir pressure is also hard-won: build-ups from different wells at different times are not the same tank pressure unless the field is well connected and given time to stabilise.

La capacidad que automatiza esto

Herramientas relacionadas

  • PVT por correlaciones

    Bubble point, solution GOR, Bo, oil and gas viscosity, z-factor and Bg from gravity, temperature and pressure — the module the other reservoir tools call.

  • POES/GOES volumétrico con Monte Carlo

    The volumetric equation run tens of thousands of times over triangular distributions, returning P90, P50 and P10 instead of one number that pretends to be certain.

  • Cribado de métodos EOR

    Ten EOR methods checked against your reservoir and fluid properties, each one told to say exactly which criterion rules it out.

  • Presión mínima de miscibilidad

    CO₂ and lean-gas MMP from three independent correlations, corrected for injectant impurities, with the spread between them shown rather than averaged away.