Herramientas

• Conversor de unidades petroleras

  Twenty-one families of upstream units, converted in one place — including the awkward ones like bbl/ft, psi/ft and millidarcy.

• Gravedad API, densidad y corrección por temperatura

  °API, specific gravity and density at 15 °C from a density observed at any temperature, with the volume correction factor that gets you there.

• Peso de lodo, gradiente y presión hidrostática

  Mud weight in any unit to a gradient and a hydrostatic pressure at any TVD — and the same calculation run backwards to an equivalent mud weight.

• Conversor de fechas jalalí, gregoriana e hijri

  One date in three calendars, for the daily drilling report that is dated in one and the contractor report that is dated in another.

• Volúmenes de pozo y tiempo de circulación

  Annular and string volumes section by section, then the strokes and the minutes to bottoms-up and to a full circulation.

• ECD y presión de fondo circulante

  Annular pressure loss, flow regime and the equivalent circulating density the formation actually sees while the pumps are running.

• Hidráulica de barrena y selección de boquillas

  Total flow area, nozzle pressure drop, HSI and jet impact force — plus the nozzle size that would put the optimum share of pump pressure at the bit.

• Survey direccional — curvatura mínima

  Paste MD, inclination and azimuth and get TVD, northings, eastings, dogleg severity, vertical section and closure — with the well path drawn.

• Hoja de control — método del perforador

  Kill mud weight, initial and final circulating pressure and the step-down schedule, for rehearsal and for checking a sheet that has already been worked.

  Apoyo de formación

• MAASP y gradiente de fractura desde LOT/FIT

  Turn a leak-off or integrity test into a fracture gradient, a maximum allowable mud weight and the surface pressure the shoe will take.

• Material densificante para cambiar el peso del lodo

  Sacks of barite to take a system from one mud weight to another, the volume it adds, and how much mud to discard if the pits cannot grow.

• Volúmenes de lechada y desplazamiento

  Slurry volume, sack count, mix water and displacement volume for a primary cement job, from the geometry and the intended top of cement.

• Torque y arrastre — modelo soft-string

  Pick-up, slack-off and rotating hookload and surface torque from a survey, a string tally and a friction factor.

• Análisis de curvas de declinación

  Paste a rate history and get an Arps fit — qi, Di and b — with the time to the economic limit, remaining reserves and an EUR.

• Curva IPR

  One well test turned into an inflow performance curve, a productivity index and an absolute open flow.

• Optimización de inyección de gas lift

  Fit a gas-lift performance curve through your injection tests and find both the technical peak and the point where the next MSCF stops paying for itself.

• Gradiente estático y presión de fondo

  Bottom-hole pressure from a wellhead reading — a liquid gradient for oil and water, and a stepwise gas-column integration for gas.

• Prueba de restauración — permeabilidad y daño

  A Horner plot from your shut-in pressures, with the semilog slope turned into permeability, skin, p* and flow efficiency.

• Altura dinámica total y número de etapas de BES

  Total dynamic head from net lift, tubing friction and discharge pressure, then the stages and shaft power that head implies.

• Caudales, corte de agua, RGP y disponibilidad

  Gross to net, cut to WOR, gas rate to GOR, and on-stream rates to calendar-day rates — the arithmetic every production report repeats and half of them get wrong.

• PVT por correlaciones

  Bubble point, solution GOR, Bo, oil and gas viscosity, z-factor and Bg from gravity, temperature and pressure — the module the other reservoir tools call.

• POES/GOES volumétrico con Monte Carlo

  The volumetric equation run tens of thousands of times over triangular distributions, returning P90, P50 and P10 instead of one number that pretends to be certain.

• Balance de materia de gas — P/z

  Paste reservoir pressure against cumulative production and read gas in place off the intercept, with z computed at every point rather than assumed constant.

• Cribado de métodos EOR

  Ten EOR methods checked against your reservoir and fluid properties, each one told to say exactly which criterion rules it out.

• Presión mínima de miscibilidad

  CO₂ and lean-gas MMP from three independent correlations, corrected for injectant impurities, with the spread between them shown rather than averaged away.

• Frecuencias de defecto de rodamientos

  BPFO, BPFI, BSF and FTF from bearing geometry and shaft speed, with the harmonics and the minimum spectrum Fmax you need to see them.

• Velocidad de corrosión y vida remanente

  Two thickness readings turned into a short-term and a long-term rate, a remaining life and the next inspection date API 510 and 570 would set.

• Resistencia remanente B31G

  A metal-loss defect assessed by both original and modified B31G, giving the failure pressure, the safe operating pressure and the longest defect your MAOP can carry.

• Espesor de pared y MAOP

  Required wall thickness and maximum allowable operating pressure under B31.3, B31.4 or B31.8, with the class location, joint and temperature factors applied.

• Caída de presión en tubería

  Single-phase liquid by Darcy–Weisbach with a real Colebrook friction factor, and gas by Weymouth with both Panhandle equations alongside it.

• Dimensionamiento de válvula de alivio (API 520)

  Required orifice area for vapour or liquid relief, mapped onto the nearest API 526 standard orifice.

• Dimensionamiento de separadores

  Vessel diameter and length from Souders–Brown gas capacity and liquid retention time, with the constraint that actually governs made visible.

• Metano venteado a CO₂ equivalente

  A vented or fugitive gas volume converted to tonnes of methane and tonnes of CO₂ equivalent on both the 20- and 100-year horizons, with an OGMP 2.0 reporting level attached.

• Intensidad de quema y emisiones de combustión

  Flare volume per barrel, the CO₂ from combustion and the methane that slips through unburned — with the combustion efficiency as the dial that matters.

• LEL de mezcla — Le Chatelier

  The lower and upper explosive limits of a multi-component gas, and where a measured atmosphere sits against them.

• Dimensionamiento de almacenamiento de series temporales

  Tag count, sample rate and retention turned into terabytes, plus the edge buffer you need to survive a link outage of a given length.

• Estimador de proyecto OCR de archivo

  Pages and scan quality turned into storage, processing hours and — the part that actually sets the schedule — the size of the human review queue.

• Ancho de banda de sitio remoto

  Tags, report rate and protocol turned into the kilobits per second a link has to carry — including the backfill surge after the link comes back.

Este cálculo se ejecutó en tu navegador. Ningún valor que introdujiste se envió a ningún sitio, y nada se guardó.