Volúmenes de pozo y tiempo de circulación
Annular and string volumes section by section, then the strokes and the minutes to bottoms-up and to a full circulation.
Perforación
Hidráulica de barrena y selección de boquillas
Total flow area, nozzle pressure drop, HSI and jet impact force — plus the nozzle size that would put the optimum share of pump pressure at the bit.
Cargando el cálculo…
Este cálculo se ejecutó en tu navegador. Ningún valor que introdujiste se envió a ningún sitio, y nada se guardó.
Cómo se calcula
- TFA = Σ π(d/32)²/4 over the open nozzles.
- Bit pressure drop = ρQ²/(12042·Cd²·TFA²) in ppg, gpm and in².
- Nozzle velocity = 0.32086·Q/TFA (ft/s); impact force = ρ·Q·Vn/1930.4 (lbf); HSI = ΔPbit·Q/1714 divided by bit face area.
- Optimum sizes are back-solved from 65 % of standpipe pressure (maximum hydraulic horsepower) and 48 % (maximum impact force).
Estándares que habla
Dónde deja de ser cierto
The discharge coefficient is an assumption, not a measurement: 0.95 is right for a clean, round, new nozzle and wrong for a worn or partially plugged one, and the pressure drop goes as 1/Cd². A bit that has been on bottom for eighty hours is not this calculation. The optimum-share rules are also rules of thumb from roller-cone practice — on a PDC in a hard formation they are, at best, a starting point.
La capacidad que automatiza esto
- DR-01Optimización de ROP en Tiempo RealRate of penetration is how fast the bit makes hole. This recommends the weight and rotation speed that make it fastest without wrecking the bit.
- DR-06Torque, Arrastre e Hidráulica en Tiempo RealCompares what the string should weigh and how hard the pumps should work against what is actually measured, and flags the gap.
Herramientas relacionadas
ECD y presión de fondo circulante
Annular pressure loss, flow regime and the equivalent circulating density the formation actually sees while the pumps are running.
Survey direccional — curvatura mínima
Paste MD, inclination and azimuth and get TVD, northings, eastings, dogleg severity, vertical section and closure — with the well path drawn.
Hoja de control — método del perforador
Kill mud weight, initial and final circulating pressure and the step-down schedule, for rehearsal and for checking a sheet that has already been worked.
Apoyo de formación