Frecuencias de defecto de rodamientos
BPFO, BPFI, BSF and FTF from bearing geometry and shaft speed, with the harmonics and the minimum spectrum Fmax you need to see them.
Instalaciones e integridad
Velocidad de corrosión y vida remanente
Two thickness readings turned into a short-term and a long-term rate, a remaining life and the next inspection date API 510 and 570 would set.
Cargando el cálculo…
Este cálculo se ejecutó en tu navegador. Ningún valor que introdujiste se envió a ningún sitio, y nada se guardó.
Cómo se calcula
- Short-term rate = (previous − current) / interval. Long-term rate = (nominal − current) / years in service.
- The governing rate is the larger of the two, as the codes require.
- Remaining life = (current − minimum required) / governing rate.
- Next inspection = half the remaining life, capped at ten years.
Estándares que habla
Dónde deja de ser cierto
Two readings define a line, and corrosion is rarely a line. Under-deposit attack, MIC and CO₂ corrosion all accelerate once initiated, so a rate averaged over ten quiet years will under-predict a mechanism that started last year. The reading also has to be at the same condition monitoring location on the same grid point to mean anything — a 0.3 mm difference is inside the repeatability of a hand-held UT probe on a rough surface, which means a short interval can produce a rate that is entirely measurement noise.
La capacidad que automatiza esto
- FA-04Corrosión e Integridad de TuberíasPredicts where a line is corroding fastest and how long it has left, so inspection and replacement go where the risk actually is.
- FA-05Planificación de Inspección Basada en RiesgoAllocates a fixed inspection budget to the equipment where failure would hurt most and is most likely, with the reasoning written down.
Herramientas relacionadas
Resistencia remanente B31G
A metal-loss defect assessed by both original and modified B31G, giving the failure pressure, the safe operating pressure and the longest defect your MAOP can carry.
Espesor de pared y MAOP
Required wall thickness and maximum allowable operating pressure under B31.3, B31.4 or B31.8, with the class location, joint and temperature factors applied.
Caída de presión en tubería
Single-phase liquid by Darcy–Weisbach with a real Colebrook friction factor, and gas by Weymouth with both Panhandle equations alongside it.