الربط مع SCADA/المؤرخ وقاعدة بيانات السلاسل الزمنية
Gets the live sensor data out of the control system safely and stores it at full resolution, which almost nothing else on this site does.
Uses the cameras already installed to spot missing protective equipment, people in restricted zones and unsafe proximity to lifting operations.
CCTV on a site is recorded and reviewed after an incident. A supervisor cannot watch forty screens, so the cameras function as an investigation tool rather than a prevention tool.
Detection and tracking models run on an edge GPU at the site, evaluating each camera against configured rules: protective equipment by zone, exclusion zones around lifting and hot work, man-down detection. Video never leaves the site and only the event record — timestamp, camera, rule, cropped frame — is stored, with retention set by the operator.
Detection accuracy falls at night, in dust and rain, and at long range, and a camera framed for general surveillance is frequently not framed well enough for a reliable protective-equipment call. Typical deployments need some camera repositioning. This produces leading indicators for supervision and is not a safety instrumented function.
كل صفحة قدرة تذكر حداً حقيقياً. إن لم يستطع المورّد إخبارك أين يتوقف منتجه، فلم يُقل لك الحق عن أين يبدأ.
Gets the live sensor data out of the control system safely and stores it at full resolution, which almost nothing else on this site does.
Knows who is on site and roughly where, so a muster after an alarm takes minutes instead of a headcount by radio.
Adds optical gas imaging and flame detection on camera to the fixed point detectors, so a leak between detectors is still seen.
Watches the flare on camera to confirm it is lit, estimate how much is being burned, and detect smoking or incomplete combustion.
A technician photographs a nameplate and the equipment record is created or matched, instead of being typed from memory later.