كشف تسرب الغاز واللهب
Adds optical gas imaging and flame detection on camera to the fixed point detectors, so a leak between detectors is still seen.
Builds a methane inventory from measurements rather than from emission factors, at the level of detail OGMP 2.0 actually asks for.
Most reported methane numbers are generic emission factors multiplied by equipment counts. OGMP 2.0 level 4 and 5 require source-level and site-level measurement, and the gap between a factor-based inventory and a measured one is routinely large.
Source-level measurements from leak surveys, optical gas imaging and continuous point sensors are reconciled against site-level measurements to produce an inventory with uncertainty at each level. Where reconciliation fails, the discrepancy is reported rather than distributed across sources, because the discrepancy is usually the most informative number in the report.
Reaching OGMP 2.0 level 5 requires site-level measurement equipment the operator may not have, and this capability cannot substitute analysis for measurement. It will produce a level 3 inventory from existing data and will state plainly what equipment is required to reach levels 4 and 5, rather than presenting an estimate as a measurement.
كل صفحة قدرة تذكر حداً حقيقياً. إن لم يستطع المورّد إخبارك أين يتوقف منتجه، فلم يُقل لك الحق عن أين يبدأ.
Adds optical gas imaging and flame detection on camera to the fixed point detectors, so a leak between detectors is still seen.
Watches the flare on camera to confirm it is lit, estimate how much is being burned, and detect smoking or incomplete combustion.
Continuously checks incoming data for stuck sensors, impossible values, missing periods and broken units, and reports the field’s data health as a number.
Flies or drives the inspection route so that people do not have to work at height or enter confined spaces as often.
Watches the control network passively for devices, traffic and commands that should not be there.